n: User Manual M-Bus Wireless / Ethernet web Document code MN67084 ENG Revision 1.100 Page 14 of 22 Industrial Electronic Devices SET COMMUNICATION This section define the fundamenta communication parameters of the two buses S Ethernet and !n Eh Set Communication wM- Bus. SW67084 By Pressing the "Set Communication / button from the main window for SW67084 ( Fig. 2) the wi indow Set Communication Setting "Set Communication , appears ( Fig. 3). The window is di ivided in two sections | wM- Bus The of the fields for "wM -| Bus Mode S means are In the field I Mode" it is possible to select the Communication Mode ( (S1 or T1 for 868 MHz Radio Channel 1a @ 4800 bps version and N1 or N2 for 169 MHz version ) used for the M-Wireless Communication V Enable Filtering In the field Radio Channel it is possible to define the Radio Channel used for the wM-Bus communication ( only for 169 MHz version ) V Received Signal Strength Indication If the field 1 Enable Filtering I is checked | it is possible to filter the data | sending on Ethernet V Link only the data defined in the section "wM-Bus Access ( 15 Quality Indication See page ) = Tf the field "Received Signal Strenght Indication / is checked | it is possibl le to add a byte at V Length the end of the Ethernet frame to indicate the Strenght of the wM-Bus signal ( dBm ) If the field "Link Quality Indication / is checked | it is possible to add a byte at the end of the Ethernet X Ethernet frame to indicate the quality of the wM -Bus si signal (1, or 3 1 IF ADDRESS : 1 Low Quality 192 168 C 2 Middle Quality SUBNET Mask C 3: High Quality 255 255 255 Tf the field "Lenght" is checked | it is possibl le to add a byte at the start of the Ethernet frame to | | indi icate the lenght of the frame ( only wM-Bus data ) GATEWAY I 192 .168 The means of the fields for 1 Ethernet are Port 10001 i In the field "IP ADDRESS" insert the IP address that you want to give to the Converter = IP Companion In the field "SUBNET Mask / insert the SubNet Mask = 192 .168 o 10 In the field 1 GATEWAY" insert the default gateway that you want to use This feature can be enabled of disabled pressing the Check Box field OK In the field 1 Port / insert the TCP port used for the Ethernet X Cancel communication In the field "IP Companion , insert the IP Address of the device to send the informations Figure 3 P "Set Communication / window from wM- Bus ADFweb.com S.r.I