jswizzle3737/ontario_laws_and_regs huggingface dataset:
Application and requirement to comply
nan
Certificates
nan
Expiry and renewal of certificates
nan
Accreditation of certain training providers
 4.1 (1) Training providers who are accredited by the director to provide training for a certificate or record of training required by Ontario Regulation 211/01 (Propane Storage and Handling), made under the Act, are deemed to have their accreditation expire on December 31, 2009.  O. Reg. 441/08, s. 1. (2) The director shall not approve or renew the accreditation of a training provider to provide training for a certificate or record of training required by Ontario Regulation 211/01, made under the Act, unless the training provider provides evidence acceptable to the director that the persons who will provide the training have subject matter and practical experience in the matters on which they will be providing training.  O. Reg. 441/08, s. 1. (3) The accreditation of a training provider to whom this section applies shall be valid for no more than three years.  O. Reg. 441/08, s. 1.
Additional requirements for G.1 certificate
nan
Additional requirements for G.2 and DA certificates
nan
Additional requirements for RV.1 certificate
nan
Additional requirements for IMT certificate
nan
LP certificates
nan
RSI-NG certificates
nan
Additional requirement for RST-NG certificate
 12.1 In addition to the requirements set out in section 5, an applicant for an RST-NG certificate shall be the holder of a G3 certificate.  O. Reg. 253/08, s. 9.
Additional requirements for ICE certificate
nan
Additional requirements for OBT-1 certificates
nan
Additional requirements for OBT-2 certificate
nan
Additional requirements for an OP certificate
nan
No transfer
nan
Notice of change of address
nan
G.1 certificate
nan
G.2 certificate
nan
G.3 certificate
nan
GPI certificate
nan
RSI-NG certificate
nan
RST-NG certificate
nan
LP certificate
nan
ICE certificate
nan
ICE-IE certificate
nan
GP certificate
nan
IMT certificate
nan
DA certificate
nan
RV.1 certificate
nan
RV.2 certificate
nan
PPO-1 certificate
nan
PPO-2 Certificate
nan
PPO-3 certificate
nan
PCI certificate
nan
PTO certificate
nan
OBT-1 certificate
nan
OBT-2 certificate
nan
OBT-3 certificate
nan
OPI certificate
nan
OP certificate
nan
OBAT certificate
nan
CH-01 certificate
nan
CH-02 certificate
nan
CH-SM1 certificate
nan
CH-SM2 certificate
nan
RE-O Certificate
nan
CDT certificate
nan
H2 certificate
 52.1 A person who holds an H2 certificate may do the following: 1. Install, inspect, alter, purge, activate, repair, service or remove hydrogen appliances, equipment, tanks, components and accessories. 2. Install, inspect, purge, activate, repair, service or remove hydrogen fuelling equipment and systems on industrial vehicles and stationary engines mounted on vehicles and motor vehicles, as those expressions are defined in the Highway Traffic Act. 3. Install, alter, service, maintain or repair hydrogen vehicle refuelling stations.  O. Reg. 256/07, s. 8.
GUT-1 certificate
 52.2 (1) A person who is the holder of a GUT-1 certificate may inspect, test, adjust, purge or activate a natural gas appliance and the equipment and accessories essential to its operation but only during those hours that the certificate holder is working as an employee of a natural gas distributor.  O. Reg. 253/08, s. 32. (2) A person referred to in subsection (1) may also do the following: 1. Inspect, test, repair, adjust, alter, purge, activate or reactivate any piping or tubing, or component in a piping or tubing system, to an appliance downstream of the natural gas meter. 2. Inspect, test, repair, adjust, activate or reactivate any vent, vent connector, draft control device or other component in an appliance venting system. 3. Disconnect and reconnect water piping in order to inspect, test, adjust, activate or reactivate approved appliances or controls, control systems, components and accessories that are essential to the operation of the appliance, but the person shall not perform any additional plumbing unless the person is the holder of a certificate of qualification or a provisional certificate of qualification in the trade of plumber or steamfitter, that is not suspended and that is issued under the Building Opportunities in the Skilled Trades Act, 2021. 4. Inspect, test, repair, adjust, activate or reactivate a mechanical or electrical component or accessory that forms part of an appliance or that is essential to the operation of the appliance. 5. Perform such tasks as are necessary to inspect, test, repair, replace and adjust controls and components that form part of an appliance. 6. Disconnect and reconnect electrical wiring in order to inspect, test, activate or reactivate an approved appliance and carry out the replacement of electrical wiring necessary to complete the reconnection of controls, control systems, components and accessories that are essential to the operation of the appliance; but the person shall not perform any additional wiring unless the person is the holder of a certificate of qualification or a provisional certificate of qualification in the trade of electrician — construction and maintenance or electrician — domestic and rural, that is not suspended and that is issued under the Building Opportunities in the Skilled Trades Act, 2021. 7. Inspect a flue where an oil appliance is vented through the same flue as a gas appliance.  O. Reg. 253/08, s. 32; O. Reg. 441/12, s. 6; O. Reg. 887/21, s. 1. (3) A natural gas distributor who employs a holder of a GUT-1 certificate shall immediately advise the director when the certificate holder ceases to be employed by the distributor.  O. Reg. 253/08, s. 32.
GUT-2 certificate
 52.3 (1) A person who is the holder of a GUT-2 certificate may inspect, test, purge, activate or remove a natural gas appliance that has an input of 400,000 Btuh or less and the equipment and accessories essential to its operation but only during those hours that the certificate holder is working as an employee of a natural gas distributor.  O. Reg. 253/08, s. 32. (2) A person referred to in subsection (1) may also do the following: 1. Perform the functions described in paragraphs 1 to 7 of subsection 52.2 (2) that the holder of a GUT-1 certificate may perform on a natural gas appliance that has an input of 400,000 Btuh or less and the equipment and accessories essential to its operation. 2. Under the direct supervision of a person who is a holder of a GUT-1 certificate, perform all of the functions that fall within the scope of the supervising certificate holder’s certificate as set out in this Regulation.  O. Reg. 253/08, s. 32. (3) A natural gas distributor who employs a holder of a GUT-2 certificate shall immediately advise the director when the certificate holder ceases to be employed by the distributor.  O. Reg. 253/08, s. 32.
Supervising certificate holder
nan
Record of training
nan