L 225/18
EN
Official Journal of the European Union
Pack sizes and packaging material
13.9.2023
1 000 litre HDPE container with HDPE closure; 200 litre plastic drum with HDPE closure; 25 litre HDPE keg with DIN 61 or equivalent HDPE screw cap; 5 litre HDPE keg with DIN 51 or equivalent HDPE screw cap.
4.2.1.
Use-specific instructions for use See general directions for use.
Product to be applied post-milking by use of a hand-held sprayer.
Pre-clean teat with dry wipe, pour the product into the reservoir of the sprayer.
The operator will spray each animal once after milking.
4.2.2.
Use-specific risk mitigation measures See general directions for use.
Professional users have to ensure that professional bystanders are not present in the treatment area during disinfection process by spraying.
If it is necessary for professional bystanders to be present, professional users have to ensure that those bystanders wear the same type of PPE as the operators.
4.2.3.
Where specific to the use, the particulars of likely direct or indirect effects, first aid instructions and emergency measures to protect the environment See general directions for use.
4.2.4.
Where specific to the use, the instructions for safe disposal of the product and its packaging See general directions for use.
4.2.5.
Where specific to the use, the conditions of storage and shelf-life of the product under normal conditions of storage See general directions for use.
5.
GENERAL DIRECTIONS FOR USE (2) OF THE META SPC 2
5.1.
Instructions for use See use-specific instruction for use of meta SPC 2.
Always read the label or leaflet before use.
The product must be brought to room temperature before use.
The amount of product applied per teat is dependent upon the animal being treated.
For large mammals (cows, camels) – up to 10 ml per teat, and for small mammals (sheep, goats) – up to 5 ml per teat.
Make sure that the teats are fully covered with disinfectant.
To ensure sufficient contact time, care should be taken that the product is not removed after application (e.g. keep the cows standing for at least 5 minutes).
5.2.
Risk mitigation measures The use of eye protection consistent with European standard EN ISO 16321 or equivalent during handling of the product is mandatory.
Avoid hand to eye transfer.
Wear protective chemical resistant gloves during product handling phase (nitrile gloves – classified under European standards EN ISO 374 or EN 455 or equivalent).
The full titles of the European standards indicated here are available under section 6.
(2) Instructions for use, risk mitigation measures and other directions for use under this section are valid for any authorised uses within the meta SPC 2.